Variable Angle Elbow (40-70 degrees) for 34mm Galv Pipe Slim Tapered Leg The 117 fittings are a

The 117 fittings are a retro-fit type fitting designed to be added on to existing structures without the need to dissassemble The 117Y fitting comes complete with 4 socket pieces and 3 plate pieces which enable each kit to be used to make one of the three possible assemblies illustrated below

The 158 Centre Cross is designed to form a 90 degree joint between an upright which passes through the fitting and four other tubes

No welding is required

NOTE: Type 150 cannot be used for tensile loads

Variable Angle Elbow (40-70 degrees) for 34mm Galv Pipe Slim Tapered Leg The 117 fittings are aWhere would you normally use this galvanised pipe fitting? The 123 B34 is a Variable 40 degree to 70 degree angle joint, often used to join staircase top rail to upright at top end of staircase. What size pipe does it fit to? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 34mm. What is it made out of? All of the pipe fittings are made from malleable iron and then hot dipped galvanised to exceed the