Trail Truss for Dynatrac ProRock 80 cage parts Can I reuse the factory

Can I reuse the factory trim instead

The areas that need to be cut are shown in the pictures

The new Motobilt Crusher rear bumper with light cut outs for the JL was designed to work with a spare tire

The Motobilt Jeep YJ ARB compressor mount will allow you to install the compressor in place of the factory AC compressor

Trail Truss for Dynatrac ProRock 80 cage parts Can I reuse the factoryA Dana 80 is built to handle weight and torque, but suspension loads still need a clear path into the axle tubes. This truss exists to create that path. It uses the factory threaded holes for alignment, then bridges over the cast center section and ties directly into the tubes so the housing carries load where it is strongest. Once welded, the truss becomes part of the axle assembly. Suspension forces transfer cleanly into the tubes, keeping the cast